mycnc:triggers_and_timers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:triggers_and_timers [2018/08/17 09:37] – pupalaiser | mycnc:triggers_and_timers [2018/08/17 09:37] – pupalaiser | ||
---|---|---|---|
Line 13: | Line 13: | ||
* After activating the timer, it is necessary to select the operating output of the controller{{ : | * After activating the timer, it is necessary to select the operating output of the controller{{ : | ||
* You must select the duration of the output pulse and the length of the pause. Values are set in ms: | * You must select the duration of the output pulse and the length of the pause. Values are set in ms: | ||
- | __//Timer 0 schedule// | + | === __//Timer 0 schedule// |
- | //__Timer 1 schedule__// | + | {{ : |
+ | === //__Timer 1 schedule__// | ||
+ | {{ : | ||
mycnc/triggers_and_timers.txt · Last modified: 2018/08/17 09:58 by pupalaiser