mycnc:touchscreen_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
mycnc:touchscreen_setup [2019/12/13 09:47] – ivan | mycnc:touchscreen_setup [2019/12/13 09:56] (current) – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
======Touchscreen setup and calibration====== | ======Touchscreen setup and calibration====== | ||
- | This manual describes the touchscreen setup process for the touchscreens provided by Puruvesi Automation. Setup of screens provided by third parties may differ. | + | This manual describes the touchscreen setup process for the 10"/ |
====10" | ====10" | ||
Line 8: | Line 8: | ||
* Screen | * Screen | ||
- | * Touchscreen panel (separate from the screen. should be overlaid on top of the screen) | + | * Touchscreen panel (separate from the screen, should be overlaid on top of the screen |
* Touchscreen driver | * Touchscreen driver | ||
* LVDS driver | * LVDS driver | ||
Line 44: | Line 44: | ||
* Connection cables | * Connection cables | ||
- | //NOTE: The HDMI/power cords are not included in the kit.// | + | //NOTE: The HDMI / 12V power supply |
Below is the connection diagram for the 15" screen: | Below is the connection diagram for the 15" screen: | ||
Line 62: | Line 62: | ||
====Touchscreen Calibration==== | ====Touchscreen Calibration==== | ||
- | //NOTE: This calibration manual is designed for Ubuntu/Ubuntu Mate users.// | + | //NOTE: This calibration manual is designed for Ubuntu |
//NOTE #2: The touchscreen driver must be connected to the PC via USB prior to beginning the calibration setup process.// | //NOTE #2: The touchscreen driver must be connected to the PC via USB prior to beginning the calibration setup process.// |
mycnc/touchscreen_setup.txt · Last modified: 2019/12/13 09:56 by ivan