mycnc:tangential_knife_support
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:tangential_knife_support [2018/08/28 21:35] – skirillov | mycnc:tangential_knife_support [2018/08/28 21:37] – skirillov | ||
|---|---|---|---|
| Line 27: | Line 27: | ||
| - | The #7005 variable can be set in Software PLC, "__HANDLER_INIT.plc". | + | The #7005 variable can be set in Software PLC, "____HANDLER_INIT.plc". |
| Software PLC procedure __HANDLER_INIT is running at the start of myCNC control software right after a complete configuration sent to the controller. | Software PLC procedure __HANDLER_INIT is running at the start of myCNC control software right after a complete configuration sent to the controller. | ||
mycnc/tangential_knife_support.txt · Last modified: 2023/01/09 11:26 by ivan