mycnc:stop_end_program
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
mycnc:stop_end_program [2020/11/20 10:01] – ivan | mycnc:stop_end_program [2024/02/21 13:54] (current) – ivan | ||
---|---|---|---|
Line 2: | Line 2: | ||
{{: | {{: | ||
+ | |||
+ | A video recap of the following manual is available on our YouTube channel: | ||
{{youtube> | {{youtube> | ||
Line 40: | Line 42: | ||
exit(99); | exit(99); | ||
};</ | };</ | ||
+ | |||
+ | :!: **NOTE:** Note the '' | ||
{{: | {{: | ||
- | If the Stop button is pressed TWICE, the OFF.plc procedure will be used. Below is the default code for the OFF.plc procedure for the X1366P profile (note that the procedures will be different for other profiles and different user cases): | + | If the Stop button is pressed TWICE, the OFF.plc procedure will be used (the OFF.plc command is also launched upon completion of every small command, including macros and single G-codes completion). |
<code C OFF.plc># | <code C OFF.plc># | ||
Line 70: | Line 74: | ||
{{: | {{: | ||
- | The two separate commands allow for a variety of stopping configurations. M02.plc procedure will often be set to have some sort of lift control to prevent issues due to the working tool potentially coming into contact with the working material/ | + | The two separate commands allow for a variety of stopping configurations. M02.plc procedure will often be set to have some sort of lift control to prevent issues due to the working tool potentially coming into contact with the working material/ |
Sometimes, when issues arise with the lift procedure, or with any of the processes described in the M02 procedure, it is advisable to click the Stop button twice in order to obtain a complete and total G-code run shutdown (if that is the way that the codes have been set up). | Sometimes, when issues arise with the lift procedure, or with any of the processes described in the M02 procedure, it is advisable to click the Stop button twice in order to obtain a complete and total G-code run shutdown (if that is the way that the codes have been set up). | ||
Line 94: | Line 98: | ||
In non-default configurations, | In non-default configurations, | ||
+ | |||
+ | |||
mycnc/stop_end_program.txt · Last modified: 2024/02/21 13:54 by ivan