mycnc:servo_on_off
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:servo_on_off [2019/10/21 14:38] – ivan | mycnc:servo_on_off [2019/10/21 14:54] – ivan | ||
---|---|---|---|
Line 5: | Line 5: | ||
---- | ---- | ||
- | The Servo ON and Servo OFF commands allow the user to create an automatic PID ON/OFF (for example, when opening/ | + | The Servo ON and Servo OFF commands allow the user to create an automatic PID ON/OFF (for example, when opening/ |
- | The automatic turning on and off of the servo motor on software start/close can be done by going into Settings > Config > PLC > Software PLC and creating %%__HANDLER.INIT%% and %%__HANDLER_EXIT%% files (if they do not yet exist) with the following code: | + | The automatic turning on and off of the servo motor on software start/close can be done by going into Settings > Config > PLC > Software PLC and creating %%__HANDLER.INIT%% and %%__HANDLER_EXIT%% files (if they do not yet exist) with the following code: |
<code c __HANDLER_INIT.PLC> | <code c __HANDLER_INIT.PLC> |
mycnc/servo_on_off.txt · Last modified: 2021/06/04 15:40 by ivan