mycnc:server_api
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:server_api [2019/10/22 11:54] – ivan | mycnc:server_api [2019/10/22 12:13] – ivan | ||
|---|---|---|---|
| Line 232: | Line 232: | ||
| The following videos show examples of using the server API to control a myCNC system (older versions of the software are used, however the principle is the same): | The following videos show examples of using the server API to control a myCNC system (older versions of the software are used, however the principle is the same): | ||
| + | |||
| ProgramFileOpen and SetScale: | ProgramFileOpen and SetScale: | ||
| {{youtube> | {{youtube> | ||
| + | |||
| Hardware Binary Outputs: | Hardware Binary Outputs: | ||
| {{youtube> | {{youtube> | ||
| + | |||
| Set Scale and Rotation Angle: | Set Scale and Rotation Angle: | ||
| {{youtube> | {{youtube> | ||
| + | |||
| {{youtube> | {{youtube> | ||
| + | |||
| {{youtube> | {{youtube> | ||
mycnc/server_api.txt · Last modified: 2022/09/07 15:33 by ivan