Differences

This shows you the differences between two versions of the page.

--- mycnc:sbc [2018/09/06 13:22] – skirillov
+++ mycnc:sbc [2018/10/10 23:28] – skirillov
@@ Line 10: / Line 10: @@
-==== Single Board Computer (SBC) perfofmance issue ====
+==== Single Board Computer (SBC) performance issue ====
 We have found an issue with OpenGL-ES driver implementation for single board computers (Tinker Board, Odroid-C2 etc).
@@ Line 32: / Line 32: @@
 If this checkbox is checked, the visualisation widget ignores position messages from the myCNC controller, does not update new work position on visualisation widget (a red cursor) and does not refresh a complete scene.
-The result is shown in a screenshot below. CPU loading drops about 5 times. Only 1 core is loaded to 40%, the rest cores are loaded less. myCNC takes only 30% from one core, the rest is taken by the Linux system.
+The result is shown in a screenshot below. CPU loading drops about 5 times. Only 1 core is loaded to 40%, the rest cores are loaded less. myCNC loads just 1 core mostly, the rest is taken by the Linux system.
@@ Line 52: / Line 52: @@
 </code>
-==== Change IP address of Single Board Computer (SBC) ====
+=== Change IP address of Single Board Computer (SBC) ===
 [[Change IP address of Single Board Computer (SBC)|Change IP address of Single Board Computer (SBC) - Odroid-C2]]
@@ Line 92: / Line 92: @@
-===== Asus Tinker Board =====
+==== Asus Tinker Board ====
 <code>
@@ Line 103: / Line 103: @@
-==== How to add new screen resolution for Tinkerboard ====
+=== How to add new screen resolution for Tinkerboard ===
 [[Add New Screen Resolution for Single Board Computer (SBC) - TinkerBoard|Add New Screen Resolution TinkerBoard SBC]]
@@ Line 172: / Line 172: @@
-==== Change IP Address for TinkerBoard SBC ====
+=== Change IP Address for TinkerBoard SBC ===
 [[Change IP address for TinkerBoard SBC]]
@@ Line 213: / Line 213: @@
-==== Touch Screen Calibration for TinkerBoard SBC ====
+=== Touch Screen Calibration for TinkerBoard SBC ===
 [[Touch Screen calibration for TinkerBoard, XFCE Window manager]]
@@ Line 239: / Line 239: @@
 {{tinker:mycnc-tinker--25.png}}
-. Press **F2**, **Enter** to save the settings. Reboot computer to aplly the changes.
+. Press **F2**, **Enter** to save the settings. Reboot the computer to apply the changes.
 {{tinker:mycnc-tinker--26.png}}