mycnc:mycnc_setup_examples
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_setup_examples [2019/06/10 09:33] – ivan | mycnc:mycnc_setup_examples [2020/01/27 11:47] – ivan | ||
---|---|---|---|
Line 9: | Line 9: | ||
2. Navigate to **Motor Outputs Configuration** | 2. Navigate to **Motor Outputs Configuration** | ||
- | 3. Assign the correct axis to each attached motor | + | 3. Assign the connected motors |
{{: | {{: | ||
- | In the same window, the general calibration for the pulses per unit can be performed. This is done in order to calibrate the software readings of the machine (how much the machine " | + | In the same window, the general calibration for the pulses per unit can be performed. This is done in order to calibrate the software readings of the machine (how much the machine " |
1. Physically record the position of the spindle/ | 1. Physically record the position of the spindle/ | ||
Line 31: | Line 31: | ||
If the new number of pulses per unit is brought up too high without changing the maximum motor speed, the motors will start making jerking movements when moved. This is due to keeping the **Max Speed** the same. In order to eliminate the jerking movements, bring down the **Max Speed** value in CNC Settings > Axes/Motors until the movement is smooth again. | If the new number of pulses per unit is brought up too high without changing the maximum motor speed, the motors will start making jerking movements when moved. This is due to keeping the **Max Speed** the same. In order to eliminate the jerking movements, bring down the **Max Speed** value in CNC Settings > Axes/Motors until the movement is smooth again. | ||
{{: | {{: | ||
+ | |||
+ | Max Speed is set in units/ | ||
+ | |||
+ | 7. Set the Backlash in units (mm/inch) for each axis. Backlash is the value that allows for some unexpected play in the machine due to clearance or looseness of mechanical parts. When the controller sends a movement command to the motor, the motor may turn briefly before any actual axis movement begins. That turn is defined as backlash, and can be accounted for in this setting. | ||
=== How to set up Tangential Knife Cutting === | === How to set up Tangential Knife Cutting === |
mycnc/mycnc_setup_examples.txt · Last modified: 2024/01/30 12:09 by ivan