mycnc:mycnc_screen_configuration
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mycnc_screen_configuration [2020/02/24 10:38] – ivan | mycnc:mycnc_screen_configuration [2020/03/10 09:09] – ivan | ||
|---|---|---|---|
| Line 722: | Line 722: | ||
| * **type** is set to " | * **type** is set to " | ||
| ++++ | ++++ | ||
| + | |||
| + | Sample code for the rotation2view element: | ||
| + | |||
| + | <gitem where=" | ||
| + | | ||
| + | | ||
| + | | ||
| + | | ||
| + | |||
| + | * **position** describes the XY location within the **where** element | ||
| + | * **width** and **height** describe the element' | ||
| + | * **table-rotation** sets the orientation of the table. //-90// and //90// are the typical values to rotate the orientation | ||
| + | * **type** is set to // | ||
| + | |||
| ==== MyCNC Actions ==== | ==== MyCNC Actions ==== | ||
mycnc/mycnc_screen_configuration.txt · Last modified: 2023/07/25 11:26 by ivan