Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_pulse_width_setup [2020/11/26 15:17] – ivan
+++ mycnc:mycnc_pulse_width_setup [2020/11/26 15:18] – ivan
@@ Line 65: / Line 65: @@
 {{:mycnc:pulse-width:pulse-width-chart2.png}}
       *The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software.
+      *The pulse width setup is now complete
          *//NOTE: The 3 different values in the **Pulse Width** line refers to the different motor outputs, in order (for example, the X+, X-, Y+ and Y- axes), and the question of which ones to fill in depends on the motors (and the number of motors) you are using AS WELL AS your controller. These values are typically left to be the same unless different motors are connected to different motor outputs (for example, a stepper/servo combo).//
            * for ЕТ6, ЕТ7 controllers - **value 1** is for the first 4 motor outputs, **value 2** is for the next 2 motor outputs
            * for ЕТ10 - all channels are equal (use **only value 1**, values 2 and 3 are not used)
            * for ЕТ15 - **value 1** is for the first 4 motor outputs, **value 2** is for the next 2 motor outputs, **value 3** is for the last 2 motor outputs
-{{:mycnc:pulse-width:pulse-width-chart3.png}}
-    *The pulse width setup is now complete.
+  *For example, you'd use values 1 and 2 when using an ET6 or an ET7 controller:
+{{:mycnc:pulse-width:pulse-width-chart3.png}}