mycnc:mycnc_pulse_width_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_pulse_width_setup [2020/01/27 10:52] – ivan | mycnc:mycnc_pulse_width_setup [2020/11/26 15:17] – ivan | ||
---|---|---|---|
Line 9: | Line 9: | ||
====Selecting the Appropriate Pulse Width for your motor==== | ====Selecting the Appropriate Pulse Width for your motor==== | ||
+ | |||
+ | {{youtube> | ||
A common procedure required for proper motor operation is selecting the appropriate pulse width for the signal going from the controller to the step/servo motor on the CNC machine. A minimum pulse width is usually noted by the motor manufacturer so as to ensure that the motor can register the signals going to it from the controller (if the pulse width is lower, then the motor cannot " | A common procedure required for proper motor operation is selecting the appropriate pulse width for the signal going from the controller to the step/servo motor on the CNC machine. A minimum pulse width is usually noted by the motor manufacturer so as to ensure that the motor can register the signals going to it from the controller (if the pulse width is lower, then the motor cannot " | ||
Line 63: | Line 65: | ||
{{: | {{: | ||
*The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software. | *The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software. | ||
- | | + | |
+ | * for ЕТ6, ЕТ7 controllers - **value 1** is for the first 4 motor outputs, **value 2** is for the next 2 motor outputs | ||
+ | * for ЕТ10 - all channels are equal (use **only value 1**, values 2 and 3 are not used) | ||
+ | * for ЕТ15 - **value 1** is for the first 4 motor outputs, **value 2** is for the next 2 motor outputs, **value 3** is for the last 2 motor outputs | ||
{{: | {{: | ||
*The pulse width setup is now complete. | *The pulse width setup is now complete. |
mycnc/mycnc_pulse_width_setup.txt · Last modified: 2024/01/22 11:05 by ivan