Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_pulse_width_setup [2019/12/27 11:27] – ivan
+++ mycnc:mycnc_pulse_width_setup [2020/01/27 10:52] – ivan
@@ Line 63: / Line 63: @@
 {{:mycnc:pulse-width:pulse-width-chart2.png}}
       *The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software.
-         *//NOTE: The first value in the **Pulse Width** line refers to the first four directions the controller can move in (for example, the X+, X-, Y+ and Y- axes), while the second value refers to the other two axes of the controller (for example, the vertical Z+ and Z- axis). These values are set to be different if the controller used on the vertical axis is separate from that used on the horizontal, and are left the same if a single controller is used. If two controllers are desired, the calculations for these values need to be performed separately based on the desired speed for each axis//
+         *//NOTE: The first value in the **Pulse Width** line refers to the first four motor outputs (for example, the X+, X-, Y+ and Y- axes), while the second value refers to the other two motor outputs (for example, the vertical Z+ and Z- axis). These values are typically left to be the same unless different motors are connected to different motor outputs (for example, a stepper/servo combo).//
 {{:mycnc:pulse-width:pulse-width-chart3.png}}
     *The pulse width setup is now complete.