User Tools

Site Tools


mycnc:mycnc_pulse_width_setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
mycnc:mycnc_pulse_width_setup [2019/04/24 13:58] ivanmycnc:mycnc_pulse_width_setup [2020/01/27 10:52] ivan
Line 63: Line 63:
 {{:mycnc:pulse-width:pulse-width-chart2.png}} {{:mycnc:pulse-width:pulse-width-chart2.png}}
       *The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software.        *The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software. 
-         *//NOTE: The first value in the **Pulse Width** line refers to the first four axes of the controller (for example, the horizontal X and Y axes), while the second value refers to the other two axes of the controller (for example, the vertical Z axis). These values are set to be different if the controller used on the vertical axis is separate from that used on the horizontal, and are left the same if a single controller is used. If two controllers are desired, the calculations for these values need to be performed separately based on the desired speed for each axis//+         *//NOTE: The first value in the **Pulse Width** line refers to the first four motor outputs (for example, the X+, X-, Y+ and Yaxes), while the second value refers to the other two motor outputs (for example, the vertical Z+ and Z- axis). These values are typically left to be the same unless different motors are connected to different motor outputs (for example, a stepper/servo combo).//
 {{:mycnc:pulse-width:pulse-width-chart3.png}} {{:mycnc:pulse-width:pulse-width-chart3.png}}
  
     *The pulse width setup is now complete.     *The pulse width setup is now complete.
mycnc/mycnc_pulse_width_setup.txt · Last modified: 2024/01/22 11:05 by ivan

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki