Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_pulse_width_setup [2020/11/26 15:18] – ivan
+++ mycnc:mycnc_pulse_width_setup [2024/01/22 11:05] (current) – ivan
@@ Line 67: / Line 67: @@
       *The pulse width setup is now complete
          *//NOTE: The 3 different values in the **Pulse Width** line refers to the different motor outputs, in order (for example, the X+, X-, Y+ and Y- axes), and the question of which ones to fill in depends on the motors (and the number of motors) you are using AS WELL AS your controller. These values are typically left to be the same unless different motors are connected to different motor outputs (for example, a stepper/servo combo).//
-           * for ЕТ6, ЕТ7 controllers - **value 1** is for the first 4 motor outputs, **value 2** is for the next 2 motor outputs
+           * for ЕТ6, ЕТ7 controllers (older ET7 versions) - **value 1** is for the first 4 motor outputs, **value 2** is for the next 2 motor outputs
-           * for ЕТ10 - all channels are equal (use **only value 1**, values 2 and 3 are not used)
+             * For ET9 controllers (modern ET7 revisions) - **value 1** is for the first 4 motor outputs, **value 2** is for the 5th motor output, **value 3** is for the 6th motor output. Read more about the ET9 [[mycnc:mycnc_et9|here]].
+           * for ЕТ10 (older ET10 revisions) - all channels are equal (use **only value 1**, values 2 and 3 are not used)
+             * For ET12 controllers (modern ET10 revisions) - **value 1** is for the first 4 motor outputs, **value 2** is for the 5th motor output, **value 3** is for the 6th motor output.
            * for ЕТ15 - **value 1** is for the first 4 motor outputs, **value 2** is for the next 2 motor outputs, **value 3** is for the last 2 motor outputs
   *For example, you'd use values 1 and 2 when using an ET6 or an ET7 controller:
 {{:mycnc:pulse-width:pulse-width-chart3.png}}