mycnc:mycnc_pulse_width_setup
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
mycnc:mycnc_pulse_width_setup [2020/11/26 10:02] – ivan | mycnc:mycnc_pulse_width_setup [2020/11/26 15:18] – ivan | ||
---|---|---|---|
Line 65: | Line 65: | ||
{{: | {{: | ||
*The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software. | *The 12 μs corresponds to Setting 7 in the chart, thus the **Pulse width** value should be set to 7 in myCNC software. | ||
- | *//NOTE: The first value in the **Pulse Width** line refers to the first four motor outputs (for example, the X+, X-, Y+ and Y- axes), | + | *The pulse width setup is now complete |
- | {{: | + | *//NOTE: The 3 different values |
+ | * for ЕТ6, ЕТ7 controllers | ||
+ | * for ЕТ10 | ||
+ | * for ЕТ15 | ||
- | | + | |
+ | {{:mycnc:pulse-width: |
mycnc/mycnc_pulse_width_setup.txt · Last modified: 2024/01/22 11:05 by ivan