mycnc:mycnc_et7
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:mycnc_et7 [2019/06/27 13:17] – ivan | mycnc:mycnc_et7 [2019/06/27 13:20] – ivan | ||
---|---|---|---|
Line 283: | Line 283: | ||
To reflash the board: | To reflash the board: | ||
- | | + | 1. Plug in the 24V DC power supply |
- | 2. Plug in the micro-USB cable into the ET7 controller & a Host Computer with myCNC installed | + | |
- | 3. Close jumpers J5(reset) & J6(programming) on the controller board | + | 2. Plug in the micro-USB cable into the ET7 controller & a Host Computer with myCNC installed |
- | 4. Open (remove) the J5 jumper. | + | |
+ | 3. Close jumpers J5(reset) & J6(programming) on the controller board | ||
+ | |||
+ | 4. Open (remove) the J5 jumper. | ||
{{: | {{: | ||
- | | + | 5. Open myCNC software on Host computer (Settings > Support Tab) |
- | 6. " | + | |
- | 7. Select " | + | |
- | 8. "UART port" select port with FT232 attached | + | |
- | 9. Baud Rate set to " | + | |
- | 10. Press " | + | |
- | 11. If " | + | |
- | 12. Remove all jumpers (J4, J5) and restart the board. | + | |
- | If the reflashing process failed, please repeat the procedure from Step 3. | + | 6. " |
- | + | ||
- | {{: | + | |
+ | 7. Select " | ||
+ | 8. "UART port" select port with FT232 attached | ||
+ | 9. Baud Rate set to " | ||
+ | |||
+ | 10. Press " | ||
+ | |||
+ | 11. If " | ||
+ | |||
+ | 12. Remove all jumpers (J4, J5) and restart the board. | ||
+ | | ||
+ | {{: | ||
+ | |||
+ | If the reflashing process failed, please repeat the procedure from Step 3. |