Differences

This shows you the differences between two versions of the page.

--- mycnc:mycnc_et7 [2019/06/10 12:34] – ivan
+++ mycnc:mycnc_et7 [2019/06/10 14:02] – ivan
@@ Line 190: / Line 190: @@
 As the sensor requires a 24V power supply, it is necessary to connect it to the 24V port, not the 5V.
-=== Switch connection example ===
+=== Switch connection example (internal power supply)===
 <code>Jumper for selected group (one of J1,J2,J3,J4) is closed.</code>
@@ Line 201: / Line 201: @@
 {{:hardware:et7:et7-switch-connection-001.jpg}}
+===Switch connection example (external power supply)
+{{:mycnc:et7-switch-connection-002-external.png}}
+{{:mycnc:et7-switch-connection-003-external.png}}
+<code>Jumpers J1, J2, J3, J4 are all open</code>
 === Spindle Speed control over DAC (0-10V) output ===