mycnc:mycnc_et15
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:mycnc_et15 [2020/05/30 11:13] – ivan | mycnc:mycnc_et15 [2020/07/05 14:24] – skirillov | ||
---|---|---|---|
Line 3: | Line 3: | ||
Currently, two breakout boards are available for the myCNC-ET15 controller: | Currently, two breakout boards are available for the myCNC-ET15 controller: | ||
- | 1) Dedicated ET15 breakout board | + | 1) ET10/ET15 board (comes with the ET10R5C controller model) |
- | 2) ET10/ET15 board (comes with the ET10R5C controller model) | + | |
+ | 2) Full dedicated ET15 breakout board | ||
Depending on the breakout board, the ET15 controller will have a different number of I/O ports. Please consult the chart below to find out the necessary model for your setup. | Depending on the breakout board, the ET15 controller will have a different number of I/O ports. Please consult the chart below to find out the necessary model for your setup. | ||
^ Specs ^ Model 1 ^ Model 2 ^ | ^ Specs ^ Model 1 ^ Model 2 ^ | ||
- | | Motor outputs | 0 | 8 | | + | | Motor outputs | 6 | 8 | |
- | | Pulse-dir | 0 | ? | | + | | Pulse-dir | 6 channels, 3MHz | 8 | |
- | | Analog -10V...+10V outputs | 6 channels | 8 channels | | + | | Analog -10V...+10V outputs | 6 channels | 8 channels, 3MHz | |
- | | Galvanic isolated inputs | 48 | 72 | | + | | Galvanic isolated inputs | 48 | 64(72) | |
- | | Encoder inputs | 6 channels | 8 channels | | + | | Encoder inputs | 4+2 channels | 8 channels | |
- | | Closed loop motion control | 6 Channels | + | | Closed loop motion control | (Pulse/ |
- | | Closed loop PWM control | 4 Channels | + | | Outputs (total) | 28 | 62 | |
- | | Built-in THC | yes | yes | | + | | Outputs (open collector) | 24 | 56 | |
- | | Outputs (total) | 28 | 72 | | + | | PWM outputs | 4 | 6 | |
- | | Outputs (open collector) | 24 | 64 | | + | | RS485 Modbus | yes | yes | |
- | | PWM outputs | 4 | 8 | | + | |
- | | Relay outputs | 0 | 0 | | + | |
- | | RS485/ | + | |
//NOTE: The above information is subject to change. // | //NOTE: The above information is subject to change. // |
mycnc/mycnc_et15.txt · Last modified: 2022/01/28 11:21 by ivan