User Tools

Site Tools


mycnc:mycnc_et10

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mycnc:mycnc_et10 [2020/01/27 10:32]
ivan
mycnc:mycnc_et10 [2020/02/06 13:06] (current)
ivan
Line 148: Line 148:
  
 MyCNC-Et10 control board has a RS485 bus connector. Modbus ASCII/RTU and Hypertherm Serial communication interfaces are implemented in myCNC-ET10 control board. MyCNC-Et10 control board has a RS485 bus connector. Modbus ASCII/RTU and Hypertherm Serial communication interfaces are implemented in myCNC-ET10 control board.
 +
 +//Note that channel #0 is reserved for special purpose applications. Please contact the myCNC development team to implement a special user case. Channel #1 can be used freely by the end user.// ​
 +
 RS485 connector pinout is shown below: RS485 connector pinout is shown below:
  
mycnc/mycnc_et10.txt ยท Last modified: 2020/02/06 13:06 by ivan