mycnc:mycnc_et10
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:mycnc_et10 [2020/01/27 10:32] – ivan | mycnc:mycnc_et10 [2020/02/06 13:06] – ivan | ||
|---|---|---|---|
| Line 148: | Line 148: | ||
| MyCNC-Et10 control board has a RS485 bus connector. Modbus ASCII/RTU and Hypertherm Serial communication interfaces are implemented in myCNC-ET10 control board. | MyCNC-Et10 control board has a RS485 bus connector. Modbus ASCII/RTU and Hypertherm Serial communication interfaces are implemented in myCNC-ET10 control board. | ||
| + | |||
| + | //Note that channel #0 is reserved for special purpose applications. Please contact the myCNC development team to implement a special user case. Channel #1 can be used freely by the end user.// | ||
| + | |||
| RS485 connector pinout is shown below: | RS485 connector pinout is shown below: | ||
mycnc/mycnc_et10.txt · Last modified: 2023/10/25 12:59 by ivan