User Tools

Site Tools


mycnc:mycnc_et10

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision
Previous revision
Next revisionBoth sides next revision
mycnc:mycnc_et10 [2019/06/27 14:00] ivanmycnc:mycnc_et10 [2019/06/28 14:03] ivan
Line 171: Line 171:
  
 ==== ET10 Firmware Reflash ==== ==== ET10 Firmware Reflash ====
 +
 +
 To reflash the board To reflash the board
  
-1. Unplug 24V DC power supply and detach ET10 controller from Breakout board+{{:mycnc:et10-firmware-reflash-002.jpg}} 
 + 
 +1. Unplug the  24V DC power supply and detach the ET10 controller from the Breakout board 
 2. Plug 24V DC supply 2. Plug 24V DC supply
 +
 3. Short power cable between ET1 and Breakout leave connected. 3. Short power cable between ET1 and Breakout leave connected.
-4. Plugin mini-USB cable to ET10 & Host Computer with myCNC installed+ 
 +4. Plug in the mini-USB cable to ET10 & Host Computer with myCNC installed 
 5. Close jumpers J4(reset) & J5)programming) on myCNC controller board 5. Close jumpers J4(reset) & J5)programming) on myCNC controller board
 +
 6. Open(remove) J4(reset) jumper. 6. Open(remove) J4(reset) jumper.
 +
 7. Open myCNC software on Host computer, then go to Settings >  Support Tab 7. Open myCNC software on Host computer, then go to Settings >  Support Tab
 +
 8. "Select board" set to "myCNC-ET10" 8. "Select board" set to "myCNC-ET10"
 +
 9. Select "Firmware version" from "Release", "Night build" or "Testing" 9. Select "Firmware version" from "Release", "Night build" or "Testing"
 +
 10. "UART port" select port with FT232 attached 10. "UART port" select port with FT232 attached
 +
 11. Baud Rate set to "115200" for ET10; other baudrate can be selected in case of problems on 115200 speed 11. Baud Rate set to "115200" for ET10; other baudrate can be selected in case of problems on 115200 speed
 +
 12. Press "Update Firmware" button, Firmware download and reflashing process will be started. 12. Press "Update Firmware" button, Firmware download and reflashing process will be started.
-13. Sector 0 will be written at the end of process, so message in debug window "Sector 0; +" means reflashing process finished successfully.+ 
 +13. Sector 0 will be written at the end of process, so message in debug window "Sector 0; +" means reflashing process finished  
 +successfully. 
 14. Remove all jumpers (J4, J5), assemble TE10 and Breakout and restart the board. 14. Remove all jumpers (J4, J5), assemble TE10 and Breakout and restart the board.
  
mycnc/mycnc_et10.txt · Last modified: 2023/10/25 12:59 by ivan

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki