User Tools

Site Tools


mycnc:mql

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mycnc:mql [2020/02/20 13:43]
ivan
mycnc:mql [2020/02/20 13:47] (current)
ivan
Line 18: Line 18:
 <​code>​This section has been copied from the Independent Pulse Generator manual linked above.</​code>​ <​code>​This section has been copied from the Independent Pulse Generator manual linked above.</​code>​
  
-=== Pulse Generator settings in the Software PLC ===+=== Software PLC for MQL ===
 The rate, ratio and acceleration can be set up in the Software PLC, as well as in the User Settings widget (the Step-Dir Coolant Control section). ​ The rate, ratio and acceleration can be set up in the Software PLC, as well as in the User Settings widget (the Step-Dir Coolant Control section). ​
  
Line 38: Line 38:
 ++++ ++++
  
-=== Pulse Generator settings in Hardware PLC ===+=== Hardware PLC for MQL === 
 + 
 +In addition to the software HANDLER_INIT PLC, certain hardware PLC procedures must be changed for the Minimum Quantity Lubrication to be set up.
  
 Function ''​coolant_motor_start()''​ is added to the ''​mill-func.h''​ file: Function ''​coolant_motor_start()''​ is added to the ''​mill-func.h''​ file:
mycnc/mql.txt · Last modified: 2020/02/20 13:47 by ivan