User Tools

Site Tools


mycnc:modbus_setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mycnc:modbus_setup [2020/02/06 13:35]
ivan
mycnc:modbus_setup [2020/03/19 10:35] (current)
ivan
Line 12: Line 12:
  
 Low-level access is preferable for direct access to the hardware. This allows to program the communication through PLC, and is a very flexible (albeit less straightforward) method. For low-level access the check mark in the **RS485/​Modbus Communication** field in the **Settings > Config > Technology > Mill/Lathe > Spindle** window to OFF. Low-level access is preferable for direct access to the hardware. This allows to program the communication through PLC, and is a very flexible (albeit less straightforward) method. For low-level access the check mark in the **RS485/​Modbus Communication** field in the **Settings > Config > Technology > Mill/Lathe > Spindle** window to OFF.
 +
 +<​code>​NOTE:​ The two modes are exclusive - low-level access will not work if the check mark is ON
 +and vice versa</​code>​
  
 ====I/O expand cards mapping==== ====I/O expand cards mapping====
mycnc/modbus_setup.txt ยท Last modified: 2020/03/19 10:35 by ivan