Differences

This shows you the differences between two versions of the page.

--- mycnc:modbus_setup [2020/02/06 13:35] – ivan
+++ mycnc:modbus_setup [2020/07/03 11:26] (current) – ivan
@@ Line 1: / Line 1: @@
 =====Modbus Setup====
+{{youtube>xb8TfhysbF8?large}}
 This article is designed to introduce the reader to the myCNC Modbus setup, as well as serve as the main reference point for all myCNC Modbus documentation.
@@ Line 12: / Line 14: @@
 Low-level access is preferable for direct access to the hardware. This allows to program the communication through PLC, and is a very flexible (albeit less straightforward) method. For low-level access the check mark in the **RS485/Modbus Communication** field in the **Settings > Config > Technology > Mill/Lathe > Spindle** window to OFF.
+<code>NOTE: The two modes are exclusive - low-level access will not work if the check mark is ON
+and vice versa</code>
 ====I/O expand cards mapping====
@@ Line 68: / Line 73: @@
 The detailed description of the available Modbus devices is located at the [[mycnc:modbus_devices|Modbus Devices]] page.
-====Sample M03 procedure for Spindle ON through Modbus====
+====Example setups====
+===General communication example===
+===Sample M03 procedure for Spindle ON through Modbus===
 ++++ Expand M03 code |