mycnc:modbus_setup
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:modbus_setup [2020/02/06 13:35] – ivan | mycnc:modbus_setup [2020/03/19 10:35] – ivan | ||
|---|---|---|---|
| Line 12: | Line 12: | ||
| Low-level access is preferable for direct access to the hardware. This allows to program the communication through PLC, and is a very flexible (albeit less straightforward) method. For low-level access the check mark in the **RS485/ | Low-level access is preferable for direct access to the hardware. This allows to program the communication through PLC, and is a very flexible (albeit less straightforward) method. For low-level access the check mark in the **RS485/ | ||
| + | |||
| + | < | ||
| + | and vice versa</ | ||
| ====I/O expand cards mapping==== | ====I/O expand cards mapping==== | ||
mycnc/modbus_setup.txt · Last modified: 2020/07/03 11:26 by ivan