User Tools

Site Tools


mycnc:independent_pulse_generator

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
mycnc:independent_pulse_generator [2020/02/20 08:54]
ivan
mycnc:independent_pulse_generator [2020/02/20 08:58] (current)
ivan
Line 35: Line 35:
 Global variable registers can be written in either Hardware or Software PLC. Global variable registers can be written in either Hardware or Software PLC.
  
-<​code>​Q:​ Why the Frequency Ratio need+<​code>​Q:​ Why is the Frequency Ratio needed
-A: Internal frequency ​unit has no sense for a normal user. It is convenient  +A: Internal frequency ​units do not make sense for a normal user. It is convenient  
-to set up the ratio and has the Frequency value in a unit usable for a user.  +to set up the ratio and has the Frequency value in a unit that would be usable for a user.  
-Depends ​on Frequency generator application the unit might be very different.+Depending ​on the Frequency generator applicationthe unit might be very different.
  
-It can be [1Hz] if you need a simple frequency generator, ​+It may be [1Hz] if you need a simple frequency generator, ​
 or [ml/hour] for Coolant control or [ml/hour] for Coolant control
 or [rpm] for Spindle speed through pulse-dir servo controller. or [rpm] for Spindle speed through pulse-dir servo controller.
Line 51: Line 51:
  
 === Pulse Generator settings in the Software PLC === === Pulse Generator settings in the Software PLC ===
-The rate, ratio and acceleration can be set up in the Software PLC as well. +The rate, ratio and acceleration can be set up in the Software PLCas well as in the User Settings widget (the Step-Dir Coolant Control section)
  
 "​HANDLER_INIT.plc"​ procedure is started just after the configuration is sent to the myCNC controller. A few lines to set up the Frequency generator can be added there. "​HANDLER_INIT.plc"​ procedure is started just after the configuration is sent to the myCNC controller. A few lines to set up the Frequency generator can be added there.
mycnc/independent_pulse_generator.txt · Last modified: 2020/02/20 08:58 by ivan