mycnc:independent_pulse_generator
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:independent_pulse_generator [2020/02/20 08:54] – ivan | mycnc:independent_pulse_generator [2020/02/20 08:58] – ivan | ||
---|---|---|---|
Line 35: | Line 35: | ||
Global variable registers can be written in either Hardware or Software PLC. | Global variable registers can be written in either Hardware or Software PLC. | ||
- | < | + | < |
- | A: Internal frequency | + | A: Internal frequency |
- | to set up the ratio and has the Frequency value in a unit usable for a user. | + | to set up the ratio and has the Frequency value in a unit that would be usable for a user. |
- | Depends | + | Depending |
- | It can be [1Hz] if you need a simple frequency generator, | + | It may be [1Hz] if you need a simple frequency generator, |
or [ml/hour] for Coolant control | or [ml/hour] for Coolant control | ||
or [rpm] for Spindle speed through pulse-dir servo controller. | or [rpm] for Spindle speed through pulse-dir servo controller. | ||
Line 51: | Line 51: | ||
=== Pulse Generator settings in the Software PLC === | === Pulse Generator settings in the Software PLC === | ||
- | The rate, ratio and acceleration can be set up in the Software PLC as well. | + | The rate, ratio and acceleration can be set up in the Software PLC, as well as in the User Settings widget (the Step-Dir Coolant Control section). |
" | " |
mycnc/independent_pulse_generator.txt · Last modified: 2022/02/11 15:45 by ivan