mycnc:global_variables_description
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| mycnc:global_variables_description [2017/09/05 17:56] – skirillov | mycnc:global_variables_description [2017/09/05 20:44] – skirillov | ||
|---|---|---|---|
| Line 20: | Line 20: | ||
| === 60011 === | === 60011 === | ||
| Writing to this register change Modbus protocol. < | Writing to this register change Modbus protocol. < | ||
| - | " | + | " |
| === 60012 === | === 60012 === | ||
| Writing to this register will change RS485/ | Writing to this register will change RS485/ | ||
| 9600, 19200, 38400, | 9600, 19200, 38400, | ||
| - | 57600, 115200</ | + | 57600, 115200</ |
| === 60013 === | === 60013 === | ||
| - | Change UART connection parameters: number of bits (8 or 7), parity (none, odd, even), number of stop bits (1, 2). Data comes in 3 low nibbles. The lowest is stop bits, then parity, then number of bits. Example: < | + | Change UART connection parameters: number of bits (8 or 7), parity (none, odd, even), number of stop bits (1, 2). Data comes in 3 low nibbles. The lowest is stop bits, then parity, then number of bits. Example: < |
| 0x712=7,O,2 | 0x712=7,O,2 | ||
| - | 0x822=8, | + | 0x822=8, |
mycnc/global_variables_description.txt · Last modified: 2022/08/04 10:58 by ivan