mycnc:global_variables_description
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:global_variables_description [2017/09/05 17:56] – skirillov | mycnc:global_variables_description [2017/09/05 20:46] – skirillov | ||
---|---|---|---|
Line 20: | Line 20: | ||
=== 60011 === | === 60011 === | ||
Writing to this register change Modbus protocol. < | Writing to this register change Modbus protocol. < | ||
- | " | + | " |
=== 60012 === | === 60012 === | ||
Writing to this register will change RS485/ | Writing to this register will change RS485/ | ||
9600, 19200, 38400, | 9600, 19200, 38400, | ||
- | 57600, 115200</ | + | 57600, 115200</ |
=== 60013 === | === 60013 === | ||
- | Change UART connection parameters: number of bits (8 or 7), parity (none, odd, even), number of stop bits (1, 2). Data comes in 3 low nibbles. The lowest is stop bits, then parity, then number of bits. Example: < | + | Change UART connection parameters: number of bits (8 or 7), parity (none, odd, even), number of stop bits (1, 2). Data comes in 3 low nibbles. The lowest is stop bits, then parity, then number of bits. Example: < |
0x712=7,O,2 | 0x712=7,O,2 | ||
- | 0x822=8, | + | 0x822=8, |
Line 43: | Line 43: | ||
=== 60031 === | === 60031 === | ||
- | Read from this register will send read inquiry to Modbus device (PLC controller will be in till Regiter value received from Modbus device). Writing to this register will send ready inquiry to Modbus device. The value written is used as Register address to read | | + | Read from this register will send read inquiry to Modbus device (PLC controller will be in till Regiter value received from Modbus device). Writing to this register will send ready inquiry to Modbus device. The value written is used as Register address to read |
+ | |||
+ | |||
+ | |||
+ | [[global_variables|Global Variables Table]] | ||
mycnc/global_variables_description.txt · Last modified: 2022/08/04 10:58 by ivan