mycnc:gcodes_list
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
mycnc:gcodes_list [2019/09/27 09:21] – ivan | mycnc:gcodes_list [2021/04/21 13:38] – ivan | ||
---|---|---|---|
Line 32: | Line 32: | ||
| G28.5 | Home Position #1 Restore | | | G28.5 | Home Position #1 Restore | | ||
| G28.6 | Home Position #2 Restore | | | G28.6 | Home Position #2 Restore | | ||
- | | G28.7 | Home Position #3 Restore | | ||
| G28.7 | Home Position #3 Restore | | | G28.7 | Home Position #3 Restore | | ||
| G28.9 | Home Position Address | | | G28.9 | Home Position Address | | ||
Line 69: | Line 68: | ||
| G64 | < | | G64 | < | ||
| G65 | G-code macro | M | | | G65 | G-code macro | M | | ||
- | | G73 | Cycle Deep Hole Drilling | M | | + | | G73 | [[mycnc: |
| G74 | Cycle Left Hand Tapping | M | | | G74 | Cycle Left Hand Tapping | M | | ||
| G76 | Cycle Lathe Thread | L | | | G76 | Cycle Lathe Thread | L | | ||
| G76 | Motion Mode Cancel| L | | | G76 | Motion Mode Cancel| L | | ||
| G80 | Cancel Motion Mode | | | | G80 | Cancel Motion Mode | | | ||
- | | G81 | Cycle Drilling | | | + | | G81 | [[mycnc: |
| G82 | Cycle Drilling Dwell | | | | G82 | Cycle Drilling Dwell | | | ||
- | | G83 | Cycle Peck Drilling | | | + | | G83 | [[mycnc: |
| G84 | Cycle Right Hand Tapping | | | | G84 | Cycle Right Hand Tapping | | | ||
| G85 | Cycle Boring No Dwell Feed Out | | | G85 | Cycle Boring No Dwell Feed Out | | ||
Line 133: | Line 132: | ||
| M64 | Turn On binary output pin | PLC | | | | M64 | Turn On binary output pin | PLC | | | ||
| M65 | Turn Off binary output pin | PLC | | | | M65 | Turn Off binary output pin | PLC | | | ||
- | | M71 | Start Cutting | PLC | Cutting Tables | | + | | M71 | Start Cutting |
| M72 | Begin Plasma Marking Section | PLC | Cutting Tables | | | M72 | Begin Plasma Marking Section | PLC | Cutting Tables | | ||
| M73 | End Plasma Marking Section | PLC | Cutting Tables | | | M73 | End Plasma Marking Section | PLC | Cutting Tables | |
mycnc/gcodes_list.txt · Last modified: 2023/09/29 14:15 by ivan