mycnc:gantry_alignment_macro_wizard
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| mycnc:gantry_alignment_macro_wizard [2020/01/27 15:23] – ivan | mycnc:gantry_alignment_macro_wizard [2020/01/31 13:46] – ivan | ||
|---|---|---|---|
| Line 275: | Line 275: | ||
| G4 P0.5 (# Pause) | G4 P0.5 (# Pause) | ||
| - | G10 L81 P810 Q800 (# Get offset in pulses) | + | G10 L81 P809 Q800 (Get offset in pulses) |
| - | G10 L192 P810 Q5531 (# Calculate offset in units/mm) | + | G10 L193 P809 Q5531 |
| - | G10 L190 P810 Q805 (# Add adjustment | + | G10 L81 P810 Q809 (Copy Offset in units/mm to #810) |
| + | G10 L190 P810 Q805 (Add tuning | ||
| M210 P0 (# OFF the second motor, the Only first motor is ON ) | M210 P0 (# OFF the second motor, the Only first motor is ON ) | ||
mycnc/gantry_alignment_macro_wizard.txt · Last modified: 2020/01/31 14:24 by ivan