mycnc:flatbed_correction
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
mycnc:flatbed_correction [2020/02/24 09:30] – ivan | mycnc:flatbed_correction [2020/02/24 14:21] – ivan | ||
---|---|---|---|
Line 15: | Line 15: | ||
{{: | {{: | ||
- | After the setup process has been completed, a table of points in the XY-plane and their Z-positions will be presented on this page. These values can either be recorded by using the AutoMeasure procedure, or by using a sensor and recording each point individually by using the M402 macro. | + | * After the setup process has been completed, a table of points in the XY-plane and their Z-positions will be presented on this page. These values can either be recorded by using the AutoMeasure procedure, or by using a sensor and recording each point individually by using the M402 macro. |
- | Using the AutoMeasure procedure, the operator can set the measurement distances for the X and Y axes as well as the number of points at which the height measurements will be taken for the XY-plane. | + | * Using the AutoMeasure procedure, the operator can set the measurement distances for the X and Y axes as well as the number of points at which the height measurements will be taken for the XY-plane. |
- | **Note:** Flatbed correction **must be disabled** prior to beginning taking the measurements, | + | * **Note:** Flatbed correction **must be disabled** prior to beginning taking the measurements, |
- | The **Auto Measure Procedure** button can be pressed to begin the probing process. | + | * The **Auto Measure Procedure** button can be pressed to begin the probing process. |
- | {{:mycnc:flatbed-update-011.png}} | + | * //NOTE: If you leave the flatbed |
- | //NOTE: If you leave the flatbed correction setting screen while the procedure | + | * After the measurement |
- | After the measurement procedure has completed and all the points are logged, select | + | * //NOTE: The myCNC flatbed correction feature is limited to 1000 pulses (+ or -) from the Reference Z position. Depending on the number of pulses per unit that you have set up in the Axes/Motors window, this may be anywhere from a centimeter |
- | //NOTE: The myCNC flatbed correction feature is limited | + | * In order to use the M402 macro for manual point measurement, |
- | In order to use the M402 macro for manual point measurement, | + | After the measurements have been taken and the Reference Z has been entered, press the Save CFG button, |
- | + | ||
- | {{: | + | |
- | + | ||
- | In order to remove any of the table level discrepancy values, you can press the Delete button for each particular value. | + | |
- | + | ||
- | {{: | + | |
By adding these correction points, myCNC software will create an updated Z-axis map of the working table. From here on, whenever Flatbed Correction is enabled, the machine will automatically adjust the z-axis height of the working tool in order to adjust for the table level changes depending on where in the XY-plane it currently is. | By adding these correction points, myCNC software will create an updated Z-axis map of the working table. From here on, whenever Flatbed Correction is enabled, the machine will automatically adjust the z-axis height of the working tool in order to adjust for the table level changes depending on where in the XY-plane it currently is. |
mycnc/flatbed_correction.txt · Last modified: 2022/12/01 11:37 by ivan