mycnc:closed_loop_configuration
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
mycnc:closed_loop_configuration [2019/10/21 09:53] – ivan | mycnc:closed_loop_configuration [2019/11/05 08:54] (current) – ivan | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== MyCNC closed loop configuration ===== | ===== MyCNC closed loop configuration ===== | ||
- | A proportional–integral–derivative controller (PID controller) is a control loop feedback mechanism widely used in industrial control systems and a variety of other applications requiring continuously modulated control. A PID controller continuously calculates an error value E(t) as the difference between the desired setpoint position (POS) and a real position measured by encoders (ENC) and applies a correction based on proportional, | + | A proportional–integral–derivative controller (PID controller) is a control loop feedback mechanism widely used in industrial control systems and a variety of other applications requiring continuously modulated control. A PID controller continuously calculates an error value E(t) as the difference between the desired setpoint position (POS) and a real position measured by [[mycnc: |
mycnc/closed_loop_configuration.txt · Last modified: 2019/11/05 08:54 by ivan