User Tools

Site Tools


mycnc:change_ip_address_of_single_board_computer_sbc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Last revisionBoth sides next revision
mycnc:change_ip_address_of_single_board_computer_sbc [2017/08/12 10:12] skirillovmycnc:change_ip_address_of_single_board_computer_sbc [2017/08/12 10:12] skirillov
Line 6: Line 6:
 There are many ways to change IP address of computer board. Linux users can do it easily without our how-to. For those who need it: There are many ways to change IP address of computer board. Linux users can do it easily without our how-to. For those who need it:
  
-<code>Notice: Network settings inLinux attached to MAC address of Network controller (wired or wireless). You may need to re-setup Network settings in case you insert new Wifi dongle (new MAC address) or update SD card image from our FTP (Network configured for tor MAC addresses of computer we prepared the image.</code>+<code>Notice: Network settings in Linux attached to MAC address of Network controller (wired or wireless).  
 +You may need to re-setup Network settings in case you insert new Wifi dongle (new MAC address) or  
 +update SD card image from our FTP (Network configured for tor MAC addresses of computer we prepared  
 +the image.</code>
  
  
mycnc/change_ip_address_of_single_board_computer_sbc.txt · Last modified: 2017/08/12 10:14 by skirillov

Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki