faq
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
faq [2020/03/02 15:29] – ivan | faq [2020/03/27 10:07] – ivan | ||
---|---|---|---|
Line 28: | Line 28: | ||
If a folder is not listed in the NC code folders list (or is not within one of the folders listed), you will not be able to open files from it within the myCNC application. | If a folder is not listed in the NC code folders list (or is not within one of the folders listed), you will not be able to open files from it within the myCNC application. | ||
+ | |||
+ | The following standard folders are used on Linux (Ubuntu MATE) installations: | ||
+ | |||
+ | '' | ||
+ | |||
+ | '' | ||
+ | |||
+ | The '' | ||
+ | |||
+ | The following standard folders are used on Windows installations: | ||
+ | |||
+ | '' | ||
+ | |||
+ | '' | ||
After you have listed the folders that you would like to have access to, you can open files using the **Open G-code** and **Open DXF** buttons from the main software screen: | After you have listed the folders that you would like to have access to, you can open files using the **Open G-code** and **Open DXF** buttons from the main software screen: | ||
Line 173: | Line 187: | ||
++++ How does the Run from Here procedure work? | | ++++ How does the Run from Here procedure work? | | ||
+ | |||
+ | {{youtube> | ||
In an event of an emergency stop or failure of a mill machine running a program file, it is often useful to be able to open the file back up afterwards and be able to continue from the middle of the program without having to go through all the steps again. This is often complicated by the fact that a large program file consists of many lines of code, making it difficult to easily navigate to the place where the cutting process stopped initially. In order to facilitate finding this spot, the Run from Here process is put in place in myCNC software. | In an event of an emergency stop or failure of a mill machine running a program file, it is often useful to be able to open the file back up afterwards and be able to continue from the middle of the program without having to go through all the steps again. This is often complicated by the fact that a large program file consists of many lines of code, making it difficult to easily navigate to the place where the cutting process stopped initially. In order to facilitate finding this spot, the Run from Here process is put in place in myCNC software. |
faq.txt · Last modified: 2024/02/20 10:07 by ivan